Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
151
Command Usage
This command is used to display configuration data for a specified port.
Shows Ethernet settings, if MAC forced forwarding is disabled or enabled.
Shows if Virtual MAC is enabled or disabled. Shows the MAC address
count limit.
Example
ecn330# show dslport 1.0.1 alarm
ecn330# show dslport 1.0.1 pvc 1
11.8.2 ecn
Use this command to display information about the ECN.
Command level: ecn330#.
Syntax
show ecn {inventory|link-aggregation|redundancy| span-
ning-tree|ip|switch-extension|auto-rediscover}
show ecn port <port> spanning-tree
Arguments:
• inventory - Show inventory.
• link-aggregation - Show all trunks configured for link aggre-
gation.
• redundancy – Show status of ECN redundancy.
• spanning-tree - Show port settings of spanning-tree parame-
ters for the elements.
• ip - Show all configurations related to IP.
• switch-extension – Show all configured switch extensions.
• auto-rediscover - Show the setting for auto rediscover
• port <port> – Show spanning tree information for the port on
the ECN switch. The port number is inserted in the range 1 to 27.
To Next Page
Loading...
