Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
121
set-on-lan’ is send, which in turn will make the element restart and run a
normal DHCP-discover sequence that makes it known to the EMP.
11.6.4 edn
Table 15 edn commands
Command Description Page
link-configuration
Set link configuration 121
11.6.4.1 link-configuration
Use this command to configure the uplink of an embedded IP DSLAM.
Command level: ecn330(config)#.
Syntax
edn <node> link-configuration {single-
link|redundancy|link-aggr}
Arguments:
• edn <node> - Specify the node no. of the EDN (IP DSLAM).
• single-link - Use this argument if there is only one uplink.
• redundancy - Use this argument if the IP DSLAM is used in redun-
dancy scenario. When this option is selected the IP DSLAM must be
connected with one uplink to an active ECN, and with the other uplink
to a standby ECN. RSTP must be enabled in both ECNs.
• link-aggr - Use this argument if link aggregation is used towards
the ECN. The link aggregation (trunk) for the two connected ports on
the ECN must be configured in the ECN using CLI commands.
Default Setting
None.
To Next Page
Loading...
