Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
97
11.6.2.7 transmission-mode
Use this command to set different ADSL standards for the connection.
Command level: ecn330(config)#.
Syntax
dslport <dslport> transmission-mode <mode>
Arguments:
• <dslport> - The DSL-port to configure. The parameter <a.b.c>
refers to the ECN port (a), the ESN108 port (b) and the IP DSLAM
line (c).
• transmission-mode <mode> - Range 1 – 16.
− 1: AUTODETECT
− 2: AUTO ADSL1
− 3: AUTO ADSL2
− 4: ANSI T1.413
− 5: ETSI TS 101 388
− 6: ITU-T ADSL over POTS, G.992.1 Annex A
− 7: ITU-T ADSL over ISDN, G.992.1 Annex B
− 8: ITU-T ADSL Lite over POTS, G.992.2 Annex A
− 9: ITU-T ADSL2 over POTS, G.992.3 Annex A
− 10: ITU-T ADSL2 over ISDN, G.992.3 Annex B
− 11: ITU-T RE-ADSL2 over POTS, G.992.3 Annex A and L
− 12: ITU-T RE-Narrow PSD ADSL2 over POTS, G.992.3 Annex
A and L
− 13: ITU-T ADSL2, G.992.3 Annex M
− 14: ITU-T ADSL2+ over POTS, G.992.5 Annex A
− 15: ITU-T ADSL2+ over ISDN, G.992.5 Annex B
To Next Page
Loading...
