Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
157
Keyword Argument Action
nodesw
Deletes the installed embedded nodes SW from the ECN
All
Deletes all the network, inventory and embedded nodes SW
from the ECN
ping*
Tests IP connection to another device
*These commands are supported in releases before EDA 2.0
Note: The fallback software on ECN is not automatically updated when
new software version is loaded. ECN will use the fallback software
that is stored on the flash card. To change the fallback software
new software must be stored on the flash card.
11.9.1.1 calendar
This command is the same as under normal operation. Please refer to sec-
tion
11.6.10.2 on page 132. This command is supported in releases before
EDA 2.0
.
11.9.1.2 exit
This command is the same as under normal operation. Please refer to sec-
tion on page
11.5.2 on page 74.
11.9.1.3 interface
This command is almost the same as under normal operation. The only dif-
ference is that it is not necessary to save the interface configuration (in-
terface activate). The activate argument does not exist in the fallback
CLI. Restart the ECN to activate the new settings (restart).
Please refer to section
11.6.10.6 page 135. This command is supported in
releases before EDA 2.0
.
11.9.1.4 restart
This command is almost the same as under normal operation. The only dif-
ference is that it is only possible to use the enc argument (it is only possi-
ble to restart the ENC from the fallback CLI).
Please refer to section
11.5.5 on page 76.
To Next Page
Loading...
