Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
79
line
Configure the ADSL transmission proper-
ties
83
performance-data
Performance data configuration 86
pvc
Configure general setting for the pvc 87
show
Show configuration
transmission-
mode
Set different ADSL standards for the con-
nection
97
Note: Please refer to EDN288 Installation Guide for information about
what parameters has to be configured as a minimum on a port.
11.6.2.1 alarm-thresholds
Use this command to set the alarm threshold in downstream direction and
upstream direction for line performance.
Command level: ecn330(config)#.
Syntax
dslport <dslport> alarm-thresholds {down-
stream|upstream} {es-15-minutes|ses-15-minutes| uas-15-
minutes|es-24-hours|ses-24-hours|uas-24-hours} <inter-
val>
Arguments:
• <dslport> - The DSL-port to configure. The parameter <a.b.c>
refers to the ECN port (a), the ESN108 port (b) and the IP DSLAM
line (c).
• downstream/upstream – The thresholds can be set for both up-
stream and downstream
• es-15-minutes – Sets the amount of Error Seconds (ES) in an
interval of 15 minutes that is accepted before an alarm is sent. ES
is a second with one or more errors.
• ses-15-minutes – Sets the amount of Severely Error Seconds
(SES) in an interval of 15 minutes that is accepted before an alarm
is sent. SES is a second with 18 or more errors.
• uas-15-minutes - Unavailable Seconds (UAS) is a second in
which the line is defined as unavailable. The line is defined as un-
available after 10 contiguous SES. The unavailable time includes
To Next Page
Loading...
