Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
137
For more information about the different interfaces please refer to section
3.2 on page 15.
Example
ecn330(config system)# interface external vlan 246 ip
192.168.35.21 netmask 255.255.255.0
ecn330(config system)# interface default-gateway
192.168.35.1
ecn330(config system)# interface internal vlan 4000 ip
172.16.100.1 netmask 255.255.0.0
ecn330(config system)# interface untagged vlan 4001 ip
172.17.30.1 netmask 255.255.255.0
ecn330(config system)# interface activate
11.6.10.7 local-management
Use this command to control untagged management traffic from an uplink
port, and direct traps to a locally connected LCT (Local Craft Tool).
Command level: ecn330(config system)#.
Syntax
local-management local-traps ip <IP_address>
local-management local-traps lct-receiver {en-
able|disable}
local-management local-traps type {1|2|3}
local-management snmp-communities read <string>
local-management snmp-communities set <string>
local-management port {25|26|27|disable}
Arguments:
• ip <IP_address> – sends traps to a remote host.The IP ad-
dress of the remote host must be specified in dotted decimal format
(xxx.xxx.xxx.xxx).
• lct-receiver enable/disable – enables or disables traps
to the LCT.
To Next Page
Loading...
