Command Line Interface
138 1553-CNH 160 0787 Uen PA2 2005-09-23
• type 1/2/3 – specifies the format of the traps:
1 – SNMP V1 traps
2 – SNMP V2 traps
3 – SNMP V2 informs
• read <string> - Specify the ‘read’ SNMP community.
• set <string> - Specify the 'set' SNMP community.
• port 25/26/27/disable – enables the designated port for
untagged management traffic or disables untagged management
traffic.
Default Setting
port disable
local-trap enabled
ip 0.0.0.0
type 3
set : public
read: public
Command Usage
This command enables or disables untagged management from one of the
uplink ports. Used before and after uploading SW from the LCT to the ECN.
Enable the local-trap to receive SNMP traps from the ECN in the connected
LCT. The type of the traps is defined by the type argument. To send traps
to another trap receiver, use the IP argument. Note that if the local-trap ar-
gument is disabled and an IP address is defined, traps will be sent only to
the remote trap receiver.
Example
ecn330(config system)# local-management port 25
ecn330(config system)# local-management local-traps
lct-receiver enable
ecn330(config system)# local-management local-traps
type 2
ecn330(config system)# local-management snmp-
communities read public
11.6.10.8 ntp
Use this command to set the NTP server and client of the ECN.
To Next Page
Loading...
