Ericsson ECN320 - Alarm-Thresholds; Alarms; Channel; Line

Command Line Interface
78 1553-CNH 160 0787 Uen PA2 2005-09-23
11.6.1 copy-dslport
Use this command to copy a DSL-port configuration from one port to an-
other.
Command level: ecn330(config)#
Syntax
copy-dslport from <dslport> to {<dslport>|all}
Arguments:
• from <dslport> - Insert the no. of the DSL-port to copy from
in the format a.b.c, which refers to the ECN port (a), the ESN108
port (b) and the IP DSLAM line (c).
• to <dslport>/all - Copy configuration to the specified DSL
port or to all the ports. Insert the DSL-port no. in the format a.b.c.
Default Setting
None.
Command Usage
This command is used to copy a DSL-port configuration from one port to
another.
Example
ecn330(config)# copy-dslport from 1.0.1 to 1.0.2
11.6.2 dslport
Table 6 dslport commands
Command Description Page
alarm-thresholds
Set the alarm threshold for line perform-
ance
79
alarms
Enable or disable line initialization failure
alarms
81
channel
Set the bit rate and interleave delay on a
line
81