Command Line Interface
144 1553-CNH 160 0787 Uen PA2 2005-09-23
• terminate - The restore must be manually terminated by this
command
Default Settings
-
Command Usage
The command is used to restore configuration information from a backup
file. The restore function will only work if the same IP address and the same
software versions is configured in the node as when the backup was made.
The daisy-chained switches and the ECN switch unit will only be restored if
the configuration file has been changed since the backup was taken.
Note: During restoring the node will restart.
Example
ecn330(config system)# restore-configuration filename
test1
ecn330(config system)# restore-configuration terminate
11.6.10.14 service-vlan
Use this command to configure or remove service VLANs.
Command level: ecn330(config system)#
Syntax
service-vlan add vlan-id <VLAN_ID> vlan-name <NAME>
service-vlan remove vlan-id <VLAN_ID>
Arguments:
• vlan-id <VLAN_ID> – The id of the Service VLAN. The range is
integer between 1 and 4092.
• vlan-name <NAME> – Alias for the Service VLAN.
To Next Page
Loading...
