Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
77
Command Usage
This command restarts nodes in the EAN.
Example
ecn330# restart ecn330
ecn330# restart node all
11.6 config
Table 5 Configuration commands
Command Description Page
copy-dslport
Copy a DSL-port configuration from one port
to another.
78
dslport
Configure a DSL-port 78
ecn Configuration commands for redundancy and link
aggregation in the ECN.
98
edn Configuration commands for single IP DSLAMs
such as link type configuration.
120
esn
Commands to configure embedded switches. 122
exn Configuration of the EXN104: packet distribution,
line-type and line settings.
125
load-
configuration
Roll back to the last saved configuration 128
reset-dslports
Reset DSL ports configuration to default 129
save-
configuration
Save the running configuration 130
system
System configuration. 130
Note: The configuration must be saved to avoid loosing the configuration
if the IP DSLAM is restarting.
To Next Page
Loading...
