Ericsson ECN320 - Esn; Link-Aggregation; Port; Spanning-Tree

Command Line Interface
122 1553-CNH 160 0787 Uen PA2 2005-09-23
Command Usage
The command will configure the IP DSLAM to use link redundancy or link
aggregation. Note that the link aggregation and link redundancy are only
supported in EDN288.
Example
ecn330# config edn 1.0 link-configuration single-link
11.6.5 esn
Table 16 esn commands
Command Description Page
link-aggregation
Configure link aggregation for ESN310
or ECN switch (not valid for ECN330
switch)
122
port
Configure spanning tree parameters or
physical mode on a port
123
spanning-tree
Configure spanning tree parameters on
the switch
124
power-on-uplink
Enable, disable or auto set PoE of up-
link port (ESN108 only)
124
11.6.5.1 link-aggregation
Use this command to configure link aggregation trunk for the ESN310
switch or the ECN switch (not valid for ECN330 switch).
Command level: ecn330(config)#.
Syntax
esn <node> link-aggregation create-trunk primary <port>
secondary <port>
esn <node> link-aggregation remove-trunk primary <port>
Arguments: