Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
149
11.7 led-test
11.7.1 led-test
Use this command to test the connections to embedded IP DSLAMs.
Command level: ecn330#.
Syntax
led-test flash
led-test node <node> line {enable|disable}
Arguments:
• flash - Will cause the embedded IP DSLAMs to turn on the
green LED in a sequence. Note that only IP DSLAMs connected di-
rectly to ports on the ECN are part of the sequence
• node <node> - Insert the node no. of the IP DSLAM in the format
a.b.
• line enable/disable – Enable or disable line state LEDS for
IP DSLAMs.
Default Setting
None
Command Usage
This command will cause the embedded IP DSLAMs to turn on the green
LED in a sequence, in order to be able to locate the ports to which each IP
DSLAM is connected. The sequence starts from the IP DSLAM connected
to port 1 of the ECN. After 250 ms the IP DSLAM connected to port two will
turn on the green LED then three and so on until port 24. When all IP
DSLAMs are lit the LEDs will turn off the light in the same order (from one
to 24) with an interval of one second.
Example
ecn330# led-test node 1.0 line enable
To Next Page
Loading...
