Ericsson ECN320 - PVC Commands

Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
87
Example
ecn330(config)# dslport 1.0.1 performance-data reset-
counters
11.6.2.6 PVC commands
Table 9 PVC Commands
pvc general
Configure general setting for the pvc 87
pvc atm
Configure ATM Service Classes, VPI and
VCI and enable upstream policing for the
PVC
89
pvc bandwidth
Set the bandwidth for a service 91
pvc ethernet
Enable forced forwarding (layer-2) and
specify MAC address count limit
93
pvc ip
Specify IP parameters 94
pvc remove
Remove the specified PVC 95
pvc vlan
Define the mapping between a PVC and
a VLAN (VLAN ID) and set the priority tag
of the VLAN (Ethernet priority).
96
11.6.2.6.1 pvc general
Used to configure general setting for the pvc.
Command level: ecn330(config)#.
Syntax
dslport <dslport> pvc <pvc> general [cpe-access-method
<access_method>] [relay-agent-configuration <relay-
agent-configuration>] [relay-agent-string <string>]
Arguments:
• <dslport> - The DSL-port to configure. The parameter <a.b.c>
refers to the ECN port (a), the ESN108 port (b) and the IP DSLAM
line (c).
• pvc <pvc> - Configure the specified PVC number. Range 1-8.