Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
95
Command Usage
This command is used to enable the subscriber to broadcast traffic on the
VLAN, to enable IGMP snooping, to add or remove one or more static IP
addresses and a default gateway.
Example
ecn330(config)# dslport 1.0.1 pvc 1 ip broadcast-allowed
enable default-gateway 192.168.1.1 igmp-snooping enable
static-ip add 192.168.1.3
11.6.2.6.6 pvc remove
Use this command to remove a pvc.
Command level: ecn330(config)#.
Syntax
dslport <dslport> pvc <pvc> remove
• remove – Remove the pvc
Arguments:
• <dslport> - The DSL-port to configure. Insert the dslport in the
format a.b.c where a.b.c refers to the ECN port (a), the ESN108
port (b) and the IP DSLAM line (c).
• pvc <pvc> - Configure the specified PVC number. Range 1-8.
Default Settings
None
Command Usage
This command is used to remove a specified pvc.
Example
ecn330(config)# dslport 1.0.1 pvc 1 remove
To Next Page
Loading...
