Command Line Interface
94 1553-CNH 160 0787 Uen PA2 2005-09-23
Example
ecn330(config)# dslport 1.0.1 pvc 1 ethernet mac-forced-
forwarding enable mac-address-count-limit 10
11.6.2.6.5 pvc ip
Use this command to specify IP parameters.
Command level: ecn330(config)#.
Syntax
dslport <dslport> pvc <pvc> ip [broadcast-allowed {en-
able|disable}] [default-gateway <IP_address>][igmp-
snooping {enable|disable}] [static-ip {add|remove}
<IP_address>]
Arguments:
• <dslport> - The DSL-port to configure. The parameter
<a.b.c> refers to the ECN port (a), the ESN108 port (b) and the
IP DSLAM line (c).
• pvc <pvc> - Configure the specified PVC number. Range 1-8.
• broadcast-allowed enable/disable - Enables the End-
user to broadcast traffic on the VLAN into which the PVC is
mapped
• default-gateway <IP_address> - Setting the IP address of
the default gateway.
• igmp-snooping enable/disable - With IGMP multicast,
parallel transmission of the same video stream is avoided. Ethernet
bandwidth is saved by snooping the streaming requests from one
user and connecting them to an already active stream towards an-
other user
• static-ip add/remove <IP_address> - Set or remove a
static IP-address.
Default Settings
igmp-snooping: enabled
broadcast-allowed: disabled
To Next Page
Loading...
