Initial Configuration and Commissioning
40 1553-CNH 160 0787 Uen PA2 2005-09-23
7.1 The ECN Local Craft Tool
The ECN Local Craft Tool (ECN LCT) is a PC or a Laptop, which must
have a CD ROM drive, an Ethernet port and a serial port. It must have two
functions:
1. Terminal emulation program such as Hyper Terminal
2. FTP Client
Using a PC with Windows 2000, XP or NT 4, will comply with these re-
quirements.
Figure 19 on page 40 illustrates the ECN LCT connected to an ECN. The
Ethernet connection can be achieved by either connecting to a local port
(any port), or remotely using the ECN IP address.
ECN
Ethernet
RS 232
SW for
EDA Nodes
ECN LCT
Figure 19 The ECN Local Craft Tool
The ECN LCT uses the SW for EDA Nodes CD ROM to upload the embed-
ded nodes SW to the ECN.
For more information about the installation, please refer to the ECN330 In-
stallation Guide or the ECN320 Installation Guide.
7.2 Installation of Software
The EAN software can be installed and/or upgraded using either the PEM
or the CLI of the ECN. The EAN application software located in the ECN
comprises the following:
1. Application SW for the Ethernet Node Controller (ENC)
To Next Page
Loading...
