Initial Configuration and Commissioning
1553-CNH 160 0787 Uen PA2 2005-09-23
41
2. Application SW for the Switching part of the ECN
3. Application SW for the embedded elements.
Note: It is important to install the software in the correct order that is in
the same order as listed above.
The application SW is delivered on the CD-ROM: “SW for EDA Nodes”.
The SW is installed directly from the CD-ROM, using the ECN Local Craft
Tool and executing the CLI commands in the following situations:
• The EAN is installed for the first time or
• The EAN has not been discovered by PEM yet or
• The PEM is not used.
For a detailed description of the CLI commands please see section
11 on
page
58.
When PEM is used the EAN application software is not installed directly
from the CD-ROM, but always from PEM
For more information about how to upgrade SW from PEM, refer to PEM
User Guide.
For more information about how to upgrade the SW from the CD ROM, re-
fer to ECN330 Installation Guide or the ECN320 Installation Guide.
To Next Page
Loading...
