Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
63
console#
The ESN310 switch can then be discovered in PEM.
It is possible to revert to an ECN320 from an ECN320/ESN310 switch by
logging in with the login: ecn320 and the password: ecn320 and perform
the basic configuration of the management VLAN ID, IP address and so on
again.
Caution!
When changing from ECN320 to ESN310 mode the IP address, VLAN ID
and default gateway will be lost and must be reconfigured.
11.2.2 Adding Switch Extensions to an EAN
To have the ECN running as a switch and be connected to an ECN (see
Figure 38 on page 63) follow the description in section 11.2.2.1 on page 64
when an ECN330 switch is connected to an ECN and section
11.2.2.2 on
page
65 when an ECN320/ESN310 switch is connected to an ECN.
Towards
broadband
backbone
A
ECN
B
ECN switch
Figure 38 ECN switch connected to ECN
To Next Page
Loading...
