Command Line Interface
96 1553-CNH 160 0787 Uen PA2 2005-09-23
11.6.2.6.7 pvc vlan
Use this command to define the mapping between a PVC and a VLAN
(VLAN ID) and set the priority tag of the VLAN (Ethernet priority).
Command level: ecn330(config)#.
Syntax
dslport <dslport> pvc <pvc> vlan [ethernet-priority
<priority>] vlan-id <vlan_id>
Arguments:
• <dslport> - The DSL-port to configure. Insert the dslport in the
format a.b.c where a.b.c refers to the ECN port (a), the ESN108
port (b) and the IP DSLAM line (c).
• pvc <pvc> - Configure the specified PVC number. Range 1-8.
• ethernet-priority <priority> - Ethernet priority sets the
priority tag of the VLAN. Range 0-7.
• vlan-id <vlan_id> - VLAN ID is a number of the VLAN. Note
that VLAN ID nr. 246, 247, 248 and 249 are the default VLAN ID for
management. VLAN ID 1 is used for untagged traffic. VLAN 4093 is
used internally. Range 2-4095.
Default Settings
ethernet-priority: 0
Command Usage
This command is used to define on which VLAN upstream traffic from this
PVC is forwarded. Also downstream traffic received on the specified VLAN
will be sent on this PVC. The command is also used to set an ethernet pri-
ority tag of the VLAN in the range of 0 – 7. Seven is the highest priority and
reserved for management.
Note: Management traffic is received and generated internally by the IP
DSLAM, and have no mapping connection with a PVC.
Example
ecn330(config)# dslport 1.0.1 pvc 1 vlan ethernet-
priority 1 vlan-id 3
To Next Page
Loading...
