Command Line Interface
88 1553-CNH 160 0787 Uen PA2 2005-09-23
• cpe-access-method <access_method> - End-users access
method to the network:
− dhcp DHCP
− static_ip Static IP
− transparent_lan Transparent LAN
− ppp_o_Ethernet PPP over Ethernet
− ppp_o_atm PPP over ATM
− ppp_automatic PPP Automatic
− static_ip_o_atm Static IP over ATM
− dynamic-ip_o_atm Dynamic IP over ATM
• relay-agent-configuration <method> - Select which
DHCP Relay Agent Information option method to use:
− 0 or not_used: Not used.
− 1 or remote_id_string: Remote ID - String - A string of up to
253 octets can be inserted.
− 2 or remote_id_ean: Remote ID – EAN - A format specified by
Ericsson.
− 3 or remote_id_customer_number: Remote ID - Customer
number - A format specified by PEM, which uses the customer
number as the id.
− 4 or circuit_id_string: Circuit ID - String - A string of up to 253
octets can be inserted.
− 5 or circuit_id_customer_number: Circuit ID - Customer num-
ber - A format specified by PEM, which uses the customer
number as the id.
− 6 or circuit_id_ean: Circuit ID – EAN - A format specified by
Ericsson.
Relay agent configuration is only used when DHCP and PPP are
selected. In the example below the number 1 has been used in the
command, thus indicating that the method: Remote ID - String has
been selected.
To Next Page
