Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
89
• Example relay-agent-string <string> \r 1-: String
of characters to be used when the method is Remote ID – String or
Circuit ID - String .
Default Settings
cpe-access-method: DHCP
relay-agent-configuration: Not used
Command Usage
The command is used to set the End-user’s access method to the network
for the service and to configure the relay agent. The relay agent configura-
tion can only be selected for a DHCP or PPP access method. The IP
DSLAM will insert an identifier in all DHCP requests or PoE Active Discov-
ery Requests (PADR) from the End-user, and thereby allow the Service
Operator (Access Provider) to authenticate and control the rights to assign
IP addresses to End-users. String is one of the identifier methods where
specific characters are inserted. A string of up to 253 octets (characters)
can be inserted. For further information refer to PEM Overview.
Note: The access method used, will depend on the equipment used by
the Service Provider and the CPE equipment.
Example
ecn330(config)# dslport 1.0.1 pvc 1 general cpe-access-
method dhcp relay-agent-configuration Remote ID -
String relay-agent-string user1-of-netservice
11.6.2.6.2 pvc atm
Used to configure ATM Service Classes, VPI and VCI and enabling up-
stream policing for the PVC.
Command level: ecn330(config)#.
Syntax
dslport <dslport> pvc <pvc> atm [atm-service-class
<class>] [upstream-policing {enable|disable}] [vci
<vci>] [vpi <vpi>]
Arguments:
To Next Page
Loading...
