Command Line Interface
86 1553-CNH 160 0787 Uen PA2 2005-09-23
Example
ecn330(config)# dslport 1.0.1 line downstream dmt-
carrier-mask
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
FFFFFFFFFFFFFFFFFF max-snr-margin 1 min-downshift-
margin 1 min-downshift-time 1 rate-adaption-mode dis-
able target-snr-margin 1
ecn330(config)# dslport 1.0.1 line downstream max-snr-
margin 9 min-downshift-margin 1 min-downshift-time 400
min-upshift-margin 6 min-upshift-time 400
ecn330(config)# dslport 1.0.1 line downstream transmit-
PSD fixed
11.6.2.5 performance-data
Use this command to reset the performance data counters.
Command level: ecn330(config)#.
Syntax
dslport <dslport> performance-data reset-counters
• performance-data – Error parameters of the line in the ADSL,
ATM, and Ethernet layers. Different counters count relevant parame-
ters in each layer.
• reset-counters - Reset the performance data counters.
Arguments:
• <dslport> - The DSL-port to configure. Insert the dslport in the
format a.b.c where the parameter a.b.c refers to the ECN port (a),
the ESN108 port (b) and the IP DSLAM line (c).
Default Settings
None
Command Usage
This command is used to reset the performance data counters that are
counting error parameters of the line in the ADSL, ATM, and Ethernet lay-
ers. Different counters count relevant parameters in each layer.
To Next Page
Loading...
