Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
81
11.6.2.2 alarms
Use this command to enable or disable line initialization failure alarms and
link up and link down alarms.
Command level: ecn330(config)#.
Syntax
dslport <dslport> alarms line-initialization-failure
{enable|disable} link-up-down {enable|disable}
Arguments:
• <dslport> - The DSL-port to configure. The parameter
<a.b.c> refers to the ECN port (a), the ESN108 port (b) and the
IP DSLAM line (c).
• line-initialization-failure enable/disable - When
enabled the alarms will be sent if training fails and the line cannot
be initialized.
• link-up-down enable/disable – To enable and disable the
link up and link down alarms.
Default Setting
disabled
Command Usage
This command is used to enable or disable line initialization failure alarms
and to enable and disable the link up and link down alarms. Alarms will give
information about the condition of the network.
Example
ecn330(config)# dslport 1.0.1 alarms line-
initialization-failure enable link-up-down enable
11.6.2.3 channel
Use this command to set the bit rate and interleave delay on a line.
Command level: ecn330 (config)#.
To Next Page
Loading...
