Command Line Interface
82 1553-CNH 160 0787 Uen PA2 2005-09-23
Syntax
dslport <dslport> channel <0> {downstream [power-down-
mode {enable|disable}]|upstream} [min-bit-rate
<min_bit_rate>][max-bit-rate
<max_bit_rate>][interleave-delay <time>]
Arguments:
• <dslport> - The DSL-port to configure. The parameter
<a.b.c> refers to the ECN port (a), the ESN108 port (b) and the
IP DSLAM line (c).
• channel <0> - Set to 0.
• downstream/upstream – Sets the downstream and upstream
parameters for the line.
• min-bit-rate <min_bit_rate> – Sets the Minimum Bit Rate
in steps of 32 kbps within the range of 32-32768 kbps for down-
stream and the range of 32-4096 kbps for upstream.
• max-bit-rate <max_bit_rate> - Sets the Maximum Bit
Rate in steps of 32 kbps within the range of 32-32768 kbps for
downstream and the range of 32-4096 kbps for upstream.
• interleave-delay <time> - Interleave delay in msec.
Range 0-128 msec.
• power-down-mode enable/disable – Enable/disable auto-
matic transition between L2 and L0 power mode.
Default Setting
Table 7 Channel default settings
Downstream Upstream
Minimum bit rate 32 kbps 32 kbps
Maximum bit rate 512 kbps 256 kbps
Interleave delay 20 msec 20 msec
To Next Page
Loading...
