Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
131
ntp
Set the NTP server and client 138
password
Change password and set minimum
length of password
140
pem-management
Enable or disable PEM management 140
radius-server
Configure or disable the configuration of
RADIUS client
142
restore-configuration
Restore configuration information in the
EMP and the embedded elements
143
service-vlan
Configure or remove Service VLANs 143
show
Show configuration 145
turn
Turn off the SBC board
update
Install ENC SW 147
vlan-unaware
Enable or disable VLAN unaware mode
of the switching unit
147
11.6.10.1 aaa
The command is used to enable or disable the configuration of the RADIUS
authentication when logging in to CLI. For further information of how to con-
figure the AAA client refer to section
11.6.10.12 on page 142.
Command level: ecn330(config system)#.
Syntax
aaa authentication login {enable|disable} radius
Arguments:
• enable/disable – enable or disable the use of an AAA server
(RADIUS server).
Default Setting
disable.
To Next Page
Loading...
