Ericsson T39 - Page 148

AT Commands Modem Terminated 146
ATZ Restore to User Profile
AT&F Set To Factory-Defined Configuration
AT&W Store User Profile
Description: This command instructs the DCE to set all parameters to their default values as
specified by the user. Uploads a set of parameters set by AT&W. This may include
taking into consideration the settings of hardware configuration switches or non-
volatile parameter storage (if implemented). If AT&W is not used, ATZ gives the same
effect as AT&F, and ATZ can be interpreted as ATH&F.
Execution command: ATZ
Extended format
command:
ATZ=<profile>
Test command: ATZ=? Shows if the command is supported.
Test command
response:
Z: (list of supported <profile>s)
Parameter:
<profile>:
<profile> Description
0 User profile to restore
Description: This command instructs the DCE to set all parameters to default values specified by
the factory. Uploads the factory defaults. This may take in consideration hardware
configuration and other factory-defined criteria.
Execution command: AT&F[=<profile>]
Test command: AT&F=? Shows if the command is supported.
Test command
response:
&F: (list of supported <profile>s)
Parameter:
<profile>:
<profile> Description
0 Resets all the settings to the factory defaults
Description: Stores the current user profile to non-volatile storage.
Execution command: AT&W[<pr>]
Test command: AT&W=? Shows if the command is supported.
Test command
response:
&W: (list of supported <pr>s)