Ericsson T39 - Page 158

AT Commands Modem Terminated 156
ATQ Result Code Suppression
ATV DCE Response Mode
Parameter:
<value>:
<value> Description
0 DCE does not echo characters during command state and
on-line command state
1 DCE echoes characters during command state and on-line
command state
Default setting
Description: Determines if the DCE transmits result codes to the DTE.
Set command: ATQ[=]<value>
Read command: ATQ? Displays the current <value> setting.
Read command
response:
Q: <value>
Test command: ATQ=? Shows if the command is supported.
Test command
response:
Q: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0 DCE transmits result codes
Default setting
1 Result codes are suppressed and not transmitted
Description: Selects either verbose or numeric response codes.
Set command: ATV[=]<value>
Read command: ATV? Displays the current <value> setting.
Read command
response:
V: <value>
Test command: ATV=? Shows if the command is supported.
Test command
response:
V: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0 Display numeric result code
1 Display verbose result code
Default setting