Ericsson T39 - Page 157

AT Commands Modem Terminated 155
ATS8 Comma Dial Modifier Delay Control
ATS10 Automatic Disconnect Delay Control
ATE Command Echo
Description: Sets the Comma dial modifier delay control. Implemented for compatibility only.
Set command: ATS8=[<delay>]
Read command: ATS8? Displays the current <delay> setting.
Test command: ATS8=? Shows if the command is supported.
Test command
response:
S8: (list of supported <delay>s)
Parameter:
<delay>:
<delay> Description
2 The value of the dial modifier delay (in seconds)
Default setting
1-255 The value of the dial modifier delay (in seconds)
Description: Specifies the amount of time that the DCE will remain connected to the line after the
absence of received line signal. This command is ignored by the infrared modem and is
implemented for compatibility reasons only.
Set command: ATS10=[<val>]
Read command: ATS10? Displays the current <val> setting.
Test command: ATS10=? Shows if the command is supported.
Test command
response:
S10: (list of supported <val>s)
Parameter:
<val>:
<val> Description
2 Remains connected for two tenths of a second
Default setting
1-254 Delay, specified in tenths of a second
Description: Determines if the DCE echoes characters received from the DTE during command
state and on-line command state.
Set command: ATE[<value>]
Read command: ATE? Displays the current <value> setting.
Test command: ATE=? Shows if the command is supported.
Test command
response:
E: (list of supported <value>s)