Ericsson T39 - Page 169

AT Commands Modem Terminated 167
AT+FRM Facsimile Receive
AT+FTH HDLC Transmit
AT+FRH HDLC Receive
Description: Starts reception of fax data at given speed.
Set command: AT+FRM=<MOD>
Test command: AT+FRM=? Shows if the command is supported.
Test command
response:
(list of supported <MOD>s)
Parameter:
<MOD>:
<MOD> Modulation Rate (bits/s)
24 Rec. V.27 ter 2400
48 Rec. V.27 ter 4800
72 Rec. V.29 7200
96 Rec. V.29 9600
Example: AT+FTM=24
CONNECT
OK
AT+FTM=?
(24,48,72,96)
OK
Description: Sets the HDLC transmit speed.
Execution command: AT+FTH=<MOD>
Test command: AT+FTH=? Shows if the command is supported.
Test command
response:
+FTH: (list of supported <MOD>s)
Parameter:
<MOD>:
<MOD> Modulation Rate (bits/s)
3 Clause 2/V.21 300
Description: Sets the HDLC receive speed.
Execution command: AT+FRH=<MOD>
Test command: AT+FRH=? Shows if the command is supported.
Test command
response:
+FRH: (list of supported <MOD>s)