Ericsson T39 - Page 177

AT Commands Modem Terminated 175
AT+FDIS Current Session Negotiation Parameters
AT+FDCS Session Results
1 1-D modified Read
2 2-D uncompressed mode
3 2-D modified Read
<ec>: Error correction.
<ec> Description
0 Disable ECM
Default setting
<bf>: Binary file transfer.
<bf> Description
0 Disable ECM
Default setting
<st>: Scan time per line.
<st> Description
0-7 0-40 ms, in steps of 5 ms
Default setting=0
Description: Allows the TE to sense and constrain the capabilities used for the current session.
Set command: AT+FDIS=<vr>,<br>,<wd>,<ln>,<df>,<ec>,<bf>,<st>
Read command: AT+FDIS? Displays the current <vr>, <br>, <wd>, <ln>, <df>, <ec>, <bf>, and
<st> settings.
Test command: AT+FDIS=? Shows if the command is supported.
Test command
response:
+FDIS: (list of supported <vr>s),(list of supported <br>s),(list of supported <wd>s),
(list of supported <ln>s),(list of supported <df>s),(list of supported <ec>s,
(list of supported <bf>s),(list of supported <st>s)
Parameters: See AT+FDCC.
Description: Reads the current session results.
Read command: AT+FDCS?
Read command
response:
+FDCS: <vr>,<br>,<wd>,<ln>,<df>,<ec> <bf>,<st>
Test command: AT+FDCS=? Shows if the command is supported.
Test command
response:
+FDCS: list of supported <vr>s),(list of supported <br>s),(list of supported <wd>s),
(list of supported <ln>s),(list of supported <df>s),(list of supported <ec>s,
(list of supported <bf>s),(list of supported <st>s)
Parameters: See AT+FDCC.
<df> Description