ESIT Smart-2 - Weighing Capacity Setting

SMART-2 Multi Functional Wireless Weighing Indicator User Manual
________________________________________________________________________________________________
Page 11
DISPLAY SETTINGS:
WARNING: In order for these menu functions to be active, the P2 connection inside
the indicator must be open circuit; otherwise only recorded information will be
displayed and they are not allowed to be changed. In this case, a special error code
(Error50) will also be displayed on the indicator's screen.
SETTING THE POINT LOCATION
If a decimal representation of the screen resolution is required, the decimal point is
set with this menu.
(1) Press key until you reach the 'Display
Settings' menu
(2) Press the key to confirm the menu
(3) The first option is the 'Decimal point' menu.
(4) Press the key to confirm the menu
(5) Set the decimal point as you desire with menu key.
then
if
then
if
then
if
then
if
(6) Press the key to save the changes.
(7) Press the key to go back to the measurement screen.