SMART-2 Multi Functional Wireless Weighing Indicator User Manual
________________________________________________________________________________________________
Page 45
WIFI Access Point ID SETTING
This menu is active only when device mode is AP.
With this menu, you can change the WIFI Access Point ID of the device. WIFI AP ID
must be one of ASCII equivalents of 0-9, a-z, A-Z characters.
(1) Press key until you reach the 'WiFi
settings' menu
(2) Press the key to confirm the menu
(3) Press key until you reach the 'Change
WIFI AP ID' menu
(4) Press the key to confirm the menu
(5) The last recorded WIFI AP ID will be displayed
on the screen and the hundreds digit blinks at
the same time
065 = hex41= “A”
NOTE: WIFI AP ID can be assigned between 0 and 255 and can be selected only
between 0-9, a-z and A-Z character range
(6) Numeric value of the blinking digit can be increased with key. The
place value can be changes with key.
(7) Press the key to save the WIFI AP ID.
(8) Press the key to go back to the measurement screen.
To Next Page
Loading...