ESIT Smart-2 - Error Codes

SMART-2 Multi Functional Wireless Weighing Indicator User Manual
________________________________________________________________________________________________
Page 64
ERROR CODES
The following error codes can be displayed on SMART-2 indicators during
measurement and as a result of incorrect setting. These error codes and their causes
are listed below
These errors indicate that the device needs to be reset or repaired
Error99
No response from ADC
Error98,97
ADC serial communication is incorrect
Error96
Bluetooth reset error
Error95
Bluetooth sleep mode error
Error94
Bluetooth name change error
Error93
Wifi APID change error
Error92
EEPROM Writing error
Error91
EEPROM full error
These Errors Can Be Fixed After The Operation Is Repeated
Error1
Weight data is above maximum value
Error2
The weight data is below the minimum value
Error3
The weight data is too large to be reset
Error4
ESC key is stuck
Error4
Menu key is stuck
Error6
Enter key is stuck
Error7
Wifi / BLE name entered incorrectly
Error8
Changing name when wifi is connected
Error9
Wifi name change error
Error10
EEPROM consumed 5% of its life
Error19
Calibration value cannot be 0
Error50
Calibration jumper inserted
0Error51
mV and V values cannot be calibrated
Error52
mV and V values cannot be reset
Error60
IP address error. The device is in STA mode but is not connected to
any network.