Ethos 1.5 Series User Manual

Ethos v1.5.7 and X18, X20 series User Manual
Smooth
If enabled a smooth curve is created through all points.
Easy mode = On
Easy mode has equidistant fixed values on the X axis, and only allows the Y coordinates
for the curve to be programmed.
Points
With Easy Mode On, only the Y coordinates may be configured (see examples above).
Easy mode = Off
Points
With ‘Easy mode’ Off, both the X and Y coordinates may be configured, (see example
above). Note that the -100% and +100% X coordinates for the curve end-points
cannot be edited, because the curve must cover the full signal range.
268 rev 2

Ethos 1.5 Series Specifications

General

Brand	Ethos
Model	1.5 Series
Category	Remote Control
Language	English