MAINTENANCE MANUAL
Page 05-34
Effectivity: All
Issue 2 | Rev. 1
HARD LANDING INSPECTION
Page: 3 of 3
Ref. Prescribed works Made by Checked by
5. COCKPIT
Ch. 27 Check all control systems for function and free
movement.
Ch. 27 Check control stops for condition and security.
76-10 Check engine control for function and free movement.
Ch. 23
Ch. 34
Check individual instruments and COMM/NAV
equipment for condition and attachment.
6. FUSELAGE
53-10
53-30
Check fuselage structure / skin for condition,
especially in the area of landing gear and wing
attachments and in the rear part of the fuselage.
53-20 Check tail skid for condition and attachment.
Ch. 27 Check control, pulleys and levers for condition.
27-20 Check rudder cables for condition.
Ch. 28 Check fuel system hoses, tubes and other fuel
system plants for condition.
7. TAIL UNIT
Ch. 55 Check tail unit structure / skin for condition.
55-10 Check attachment stabilizer-fuselage for condition.
55-10 Check play of attachments – move the stabilizer
upward/downward, frontward/rearward.
55-20
55-40
Check rudder and elevator hinges for condition and
free movement.
8. FINISHING WORKS
Check the completeness of tools and instruments
used during the inspection.
06-40 Install and close all covers and hatches.
Lower the airplane.
Fill out the record about a hard landing inspection in
the logbook.
Contact airplane manufacturer if permanent
deformation, cracks or exceeded allowable value of
play were found.
Date: ........................................ Signature: ........................................
To Next Page
Loading...
