Evector SportStar RTC - Battery IBBS-12 V-3 Ah

MAINTENANCE MANUAL
ERTC022-10-AS
Effectivity: All
24-30
Page 24-29
2019-03-22
Edition 2 | Rev. 1
I. Battery IBBS-12v-3ah
Maintenance type: Line
Personnel
qualification:
Independent verification personnel qualified in accordance with Part
66 or higher
Recommended tools and material:
Item Designation / Size Quantity Note
Wrench No. 7 1 pc.
Flat screwdriver - 1 pc.
Cable tie 2,5x99 As needed
(1) Removal – battery IBBS-12v-3ah
(a) Switch the electrical network off and disconnect the battery.
(b) Remove the cover of the upper part of fuselage F4 (Section 53-30).
(c) Disconnect the connector (2, Fig. 24-13) from the harness.
(d) Unscrew and remove the nuts (4), washers (5) and the screws (3).
(e) Remove the battery (1).
(2) Installation – battery IBBS-12v-3ah
(a) Place the battery (1, Fig. 24-13) on the brackets (5; 6) and attach it by means of
the screws (3), washers (5) and the nuts (4).
(b) Connect the connector (2) to the harness.
(c) Install the cover of the upper part of the fuselage F4 (Section 53-30).
(d) Connect the battery.