746 C - 844 C 51 532150 - Rev.A
Translation of the original instructions
ENGLISH
GATE
Check the frame: make sure that it is fixed correctly, that it is intact and that there is no deformation or
damage. Tighten screws and bolts where necessary.
See manufacturer's instruc-
tions
Check the leaf: make sure that it is intact and that there is no deformation or damage.
See manufacturer's instruc-
tions
Check that the pedestrian door integrated in the sliding leaf is intact (if present).
See manufacturer's instruc-
tions
Check that the bearings are in good condition and there is no friction. Check the wheels, ensuring that
they are intact, correctly fastened and free of deformation, wear and rust.
See manufacturer's instruc-
tions
Check the rack, ensure it is straight, not worn, that it is the correct distance from the pinion along its entire
length and correctly fastened to the gate.
12
Cantilever gate, check the solidity of the guide system for the suspended leaf and the counterweight,
if present.
See manufacturer's instruc-
tions
Perform a general clean of the area of movement of the gate. 12
Make sure that the pictograms are present and intact. If they are missing or damaged, replace them. 12
PROTECTIVE DEVICES AND CONTROL DEVICES
Check that the protective devices are intact and that they operate correctly.
See manufacturer's instruc-
tions
Check that the control devices are intact and that they operate correctly.
See manufacturer's instruc-
tions
Check that each pair of photocells is working correctly and that there is no optical/light interference
between the pairs of photocells.
6
Check that indicator lights are intact that they are working correctly, if present.
See manufacturer's instruc-
tions
GATE COMPLETE WITH GEARMOTOR
Check that the gate operates properly in both directions with all the devices installed. 6
Check that the gate moves correctly - smooth, regular and without making abnormal l noises. 6
Check that both the opening and closing speed are correct and that the expected stop positions and
slowdowns are correct.
6
Check that the safety devices (e.g. sensitive edges) are working correctly, if present. 6
Repeat the operations in the "Final checks" section. 6
Check that the gate's CE marking and the DANGER, AUTOMATIC MOVEMENT warning sign is present,
intact and legible.
12
To Next Page
Loading...
