User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 33
ctrl+Jump jump to next or previous Mark (stored timecode location in the Project)
Shift+Jump jump to next or previous Point (Head, Tail or Sync Point of a clip, on any selected
track)
ctrl+Shift+Jump jump to the beginning or end of the Project
Range+Jump jump to the Head or Tail of the Range (a Range must exist for this to work)
Jump+1 jump by one second
Jump+2 jump by two seconds (and so on up to 9 seconds)
Jump+0 jump by ten seconds
Jump+00 jump by one frame
Jump+Clear jump to the previous frame edge (unless already on one)
Locators
Overview
Xynergi provides three non-permanent Locators to use freely in editing or mixing. They are
designed to use quickly, and are not saved with the Project (Marks are saved, see Using Marks.)
Locators are stored using the
Set key next to the Numeric Keypad, and recalled using the Loc key
above it.
Get Ready
Make sure the Go To menu is not active.
Storing Locators
To store a location, press the Set button, then press 1, 2 or 3. While Set is active you can store
other locations.
You can also use
Set in momentary style. Hold it down, press a number, then release it. The
system will exit Set mode.
Going to a Location
To locate to a stored location, press the Loc button, then press 1, 2 or 3.
You can also use
Loc in momentary style. Hold it down, press a number, then release it. The
system will exit Loc mode.
You can leave the
Loc button latched if you wish to use locators a lot. They can be interrupted
temporarily by pressing
Fadersets, Go To, BLUE or the Set button. But if you wish to use the
Numeric Keypad for typing numbers, you must turn
Loc off.
Using Marks
Overview
Xynergi allows you to create up to 100 timecode Marks, which are stored in the Project file.
To create a mark, press the Mark button at any time. This will put a Mark at the current timecode
position.
To Next Page
Loading...