User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 59
Click Name if you want to name the Speaker set
Press the
end soft key to leave the Config Monitors screen.
Choose Monitor Speaker Outputs
Overview
The system allows you to define many speaker sets. There is always a MAIN set, usually your
large Control Room monitors. You may also create many other sets and choose them whenever
you like.
This guide will show you how to choose outputs for any of your speaker sets.
Get Ready
Press the green Mon button.
Press the
Mon Setup button if it’s not already lit.
Set Outputs
Press the Config Monitors soft key and work on the Mixer Screen
Choose a
Speaker set at the lower left.
Select all (or one) of its Elements at the top left.
Click
Analog (or Digital) Outputs at lower right.
Choose the right number of free outputs to match the number of selected elements. Click
Patch.
Repeat as needed.
Press the
end soft key to leave the Config Monitors screen.
Change Monitor Listening Format
Overview
You can tell the system to play into a narrower format than your current speaker set. This is
called “folding down”.
For example, you can listen to your 5.1 mix in stereo, without changing speaker sets, by changing
the Listening format.
The system remembers the last non-standard listening format you used, and calls it the
Alternative Format. This can be heard at any time by pressing the ALT Format button in the Mon
Megamode (press
mon then ALT Format)
This guide will show you how to choose a listening format.
Get Ready
Press the green Mon button.
Press the
Format Setup button.
Choose Format
Select any of the formats shown on the soft keys. The system immediately switches to that
format.
To Next Page
Loading...