User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 78
Threshold, Ratio / Range and Makeup Gain controls at left and Hold, Attack and Release times at right.
Hold down the ALT key for more functions.
Dyn – ALT
For each mode, the IN / OUT switch is an upper soft key
The three Dynamics modes are selected on the lower soft keys.
Aux
There are three modes for Auxiliary send control. To switch between modes, ALT + lower soft
keys
.
Each mode handles 4 of the Aux sends.
Level is shown as OFF if below -99dB.
Pan values percentage left/right of center.
Hold down the
ALT key for more functions.
Press the
Path, EQ or Dyn buttons for their details.
Aux – ALT
The three Aux modes are selected on the lower soft keys.
Aux sends are Muted using the ON / MUTE button.
Path Copy
Overview
Path Copy allows you to copy all or part of the settings from one path to another.
It works by first copying the all the settings from a source path into the clipboard, then pasting
the desired parts into a destination path.
This guide shows you how to perform a Path Copy.
Get Ready
Press the green Mixer button.
Press the
Path Copy button.
Operation
Select the source path.
Press the
COPY soft key.
Select the destination path. Press one of the
Paste soft keys.
Library
Overview
Xynergi's library provides storage for groups of settings that you can recall at any time and apply
to any signal path.
To Next Page
Loading...