Fairlight Xynergi - Inserts

User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 79
The library can be operated on screen with the mouse, or using the Pad soft keys. This guide will
show you how to do it with the mouse.
Get Ready
Press the green Mixer button.
Press the
Lib button.
Operation
To store a new library item, do the following on the Mixer screen:
Select the
source path by clicking on it. Click the path type (Track, Live, Aux-Bus etc) if
necessary.
Select the type of setting you would like to save (EQ, Dynamics, Whole Channel, Whole Console
or Plug-in). Click the
Save As button and supply a name. Press Enter
To overwrite an existing library item, select it and click the
Save button. Items are displayed at
the upper left.
To apply a library item, select the type of setting, select the item, select the
destination
path(s)
and click Apply.
Inserts
Overview
Inserts can be switched on and off in the Path display using the Pad Soft Keys (when holding
down the
ALT button, or when the Pad Lock mode is active).
Inserts are used for getting signals out of the system and back in again. They are also used to
place Plug-ins in a signal path.
The first step in working with an Insert is to set its physical input and output. This guide shows
you how to configure these, and how to insert plug-ins.
Get Ready
Press the green Mixer button.
Select the path whose inserts you wish to configure. Press the
Insert Config button.
Operation
To work on insert sends, press the Sends Returns toggle so that the > points to Sends. For insert
returns, do the opposite.
To set up the physical I/O for a send or return press the
Patch soft key. Operation is the same as
How To  Recording  Patch Inputs.
To insert a Plug-In, press the
Add Plug-In soft key, then use the Jog Wheel to scroll through the
list of available items. Press the
Add soft key to apply. The graphical controls for the Plug-in will
be displayed on the Edit Screen.
Plug-ins can be organised into a list of favourites by pressing the
Add to Fav soft key. Press the
Fave soft key to display only this list.
Press the
Plug Ins button at any time to toggle the Plug-ins editor
You can select another path while the Insert Config layout is active.