Fargo DTC300 - Printer Module: Flipper Table Module Assembly (D900200)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC300/DTC300M Card Printer/Encoder User Guide (Rev. 2.2)
2-14
Printer Module: Flipper Table Module Assembly (D900200)
The Flipper Table Module Assembly (D900200) is an automated Flipping Module that allows
the Printer to print on the frontside and backside of each card.
 See the Installing the Flipper Table Module Assembly (D900200) procedure.
 See the Flipper Table Module Assembly Problems procedures.
 See the Print Both Sides option in the Using the Device Options tab
(DTC300/DTC300M) section.
 See the Front and Back radio buttons in the Using the Overlay / Print Area tab
(DTC300/DTC300M) section.
 See the Front and Back radio buttons in the Using the K Panel Resin tab
(DTC300/DTC300M) section.
 See the DTC300/DTC300M Card Printer User Guide for the replacement procedures for
this Printer.