Fargo DTC300 - Section 3: Setup and Installation Procedures; Table of Contents

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC300/DTC300M Card Printer/Encoder User Guide (Rev. 2.2)
3-1
Section 3: Setup and Installation
Procedures
The following guide will walk you through the installation of the DTC300/DTC300M Card
Printer Driver.
 Time Requirement (software): This software installation process will require
approximately 2 to 5 minutes (depending on the speed of your PC).
 Time Requirement (Printer): The time required to set up a standard DTC300/DTC300M
Printer would be approximately 5 to 10 minutes.
The System Requirements are as follows:
IBM-PC or compatible, Windows® 98SE, Me/2000/XP, Pentium® class 233MHz computer
with 64MB of RAM or higher, 200MB free hard disk space or higher, USB 1.1
Table of Contents
Section 3: Setup and Installation Procedures ___________________________________3-1
Table of Contents ___________________________________________________________________ 3-1
Printer Setup and Installation __________________________________________________________ 3-3
Choosing A Good Location _________________________________________________________ 3-3
About Moisture Condensation _______________________________________________________ 3-3
Unpacking and Inspection __________________________________________________________ 3-4
Reviewing the Printer (front view)____________________________________________________ 3-5
Reviewing the Printer (front view; Cartridge being installed) _______________________________ 3-5
Reviewing the LCD (top-front part of Printer)___________________________________________ 3-6
Connecting the Printer power________________________________________________________ 3-7
Installing the Print Ribbon Cartridge __________________________________________________ 3-8
Installing the Print Ribbon Cartridge (continued) ______________________________________ 3-9
Installing the Print Ribbon Cartridge (continued) _____________________________________ 3-10
Installing Blank Cards into the Card Hopper ___________________________________________ 3-11
Installing Blank Cards into the Card Hopper (continued) _______________________________ 3-12
Installing Blank Cards into the Card Hopper (continued) _______________________________ 3-13
Lowering the Card Output Hopper___________________________________________________ 3-14
Flipper Table Module Installation______________________________________________________ 3-15
Installing the Flipper Table Module Assembly (D900200) ________________________________ 3-15
Installing the Flipper Table Module Assembly (D900200) (continued) ____________________ 3-16
Installing the Flipper Table Module Assembly (D900200) (continued) ____________________ 3-17
Printer Driver Installation ____________________________________________________________ 3-18
Installing the Printer Driver ________________________________________________________ 3-18
Installing the Printer Driver (continued) ____________________________________________ 3-19
Installing the Printer Driver (continued) ____________________________________________ 3-20
Installing the Printer Driver (continued) ____________________________________________ 3-21
Installing the Printer Driver (continued) ____________________________________________ 3-22
Installing the Printer Driver (continued) ____________________________________________ 3-23
Installing the Printer Driver (continued) ____________________________________________ 3-24
Installing the Printer Driver (continued) ____________________________________________ 3-25
Installing the Printer Driver (continued) ____________________________________________ 3-26
Installing the Printer Driver (continued) ____________________________________________ 3-27
Installing the Printer Driver (continued) ____________________________________________ 3-28
Installing the Printer Driver (continued) ____________________________________________ 3-29
Printing a Test Print Image_________________________________________________________ 3-30