Fargo DTC300 - Resolving a Ribbon out Error

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC300/DTC300M Card Printer/Encoder User Guide (Rev. 2.2)
4-23
Resolving a Ribbon Out Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
 Symptom: Printer will not print.
 Printer Error State: The Ribbon Sensor has detected the End Of Ribbon
mark
 LCD Error Display: Ribbon Out
 Driver Monitor Error Display: Ribbon Out
2 Replace the Ribbon Cartridge
a. Press on the Resume button.