Fargo DTC300 - Resolving the Flipper Jam Error

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC300/DTC300M Card Printer/Encoder User Guide (Rev. 2.2)
4-39
Resolving the Flipper Jam Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer. See the Flipper Table Module Installation section (as needed).
Step Procedure
1 Review the following information.
 Symptom: The Flipper Table Module is jamming.
 Printer Error State: The Flipper Table has jammed while either aligning
itself or flipping a card.
 LCD Error Display: Flipper Jam
 Driver Monitor Error Display: Flipper Jam