Fargo DTC400 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
4-52
Resolving the Image Placement problems (continued)
Step Procedure
4
Verify if the Vertical Image Position Setting is set correctly or incorrectly. See
the graphic below.
 If the white border is on the top edge of the card, adjust the Vertical value
by +2.
 If the white border is on the botom edge of the card, adjust the Vertical
value by -2.
a. Click on OK.
b. Run a self-test.
c. If the white border is diminished, continue the adjustment until it is gone.
Graphic B

Fargo DTC400 Specifications

General

Print Resolution	300 dpi
Connectivity	Ethernet (optional)
Dimensions	254 x 254 x 229 mm (10 x 10 x 9 in)
Weight	6.8 kg (15 lbs)
Print Technology	Dye-Sublimation / Resin Thermal Transfer
Card Capacity	100 cards (input hopper)
Card Sizes Accepted	CR80 (3.375" x 2.125")
Card Thickness	0.76 mm (30 mil)
Memory	32 MB RAM
Operating System Supported	Windows
Operating System Compatibility	Windows 7, 8, 10 (32-bit and 64-bit)
Print Area	Full bleed