EasyManuals Logo

Fargo DTC400 User Manual

Fargo DTC400
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #277 background imageLoading...
Page #277 background image
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
6-96
Using the Magnetic Encoder Voltage Offset Option
Use this option to adjust the voltage of the Magnetic Encoder.
ï‚· Encoder voltage is set from the factory at a default of 7.24vdc for Hi-Co Magnetic cards
and 2.54vdc for Lo-Co Magnetic cards.
ï‚· Depending on the cards that are being used, it may be necessary to adjust the encoder
voltage out of default.
See the next two procedures for instructions on adjusting the Magnetic Encoder Voltage.
(Note: The required encoder voltage for the cards will need to be known in order to properly
set the Encoder Voltage Offset value. This information should be available through the card
manufacturer or reseller).

Table of Contents

Other manuals for Fargo DTC400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fargo DTC400 and is the answer not in the manual?

Fargo DTC400 Specifications

General IconGeneral
BrandFargo
ModelDTC400
CategoryPrinter
LanguageEnglish

Related product manuals