Fargo DTC400 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
5-49
Additional Procedures
Reviewing LED and Dipswitch Tables
The LEDs and dipswitches can be found on the back of Printers.
Reviewing the LED Table
LED DTC400
position
HDP600
position
Flash Rate Indicates
On once per second
(i.e., more OFF than ON)
The Normal Mode, IP
address is configured.
On twice per second The IP address is not
configured.
Off once per second
(i.e., more ON than OFF)
The Download mode is for
updating the Ethernet
interface.
STAT
LED
Upper Right
Off twice per second There is a system error.
On The Network link is present.
Off The Network link is not
present.
NET
LED
Lower Left
Blinking, off 1/3 second The Network link is present
and transmitting. It flashes off
for one-third (1/3) second
each time a packet is
transmitted.

Fargo DTC400 Specifications

General

Print Resolution	300 dpi
Connectivity	Ethernet (optional)
Dimensions	254 x 254 x 229 mm (10 x 10 x 9 in)
Weight	6.8 kg (15 lbs)
Print Technology	Dye-Sublimation / Resin Thermal Transfer
Card Capacity	100 cards (input hopper)
Card Sizes Accepted	CR80 (3.375" x 2.125")
Card Thickness	0.76 mm (30 mil)
Memory	32 MB RAM
Operating System Supported	Windows
Operating System Compatibility	Windows 7, 8, 10 (32-bit and 64-bit)
Print Area	Full bleed