Fargo DTC400 - Resolving a Headlift Motor or Sensor Error

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
4-32
Resolving a Headlift Motor or Sensor Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
 Symptom: The Printhead continuously cycles or does not cycle at all
 Printer Error State: Headlift Sensor is not detecting movement from the
Headlift Cam
 LCD Error Display: Head Lift Error
 Driver Monitor Error Display: General Error