Fargo DTC400 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
5-6
Network Management Interface
The SNMP interface is described below.
Interface Description
SNMP
 The Ethernet interface is a fully-manageable SNMP agent that supports
MIB-II.
 The Ethernet interface is MIB II compliant, allowing SNMP managers to
monitor protocol, network and routing statistics.
Telnet Command Line Interface
Initiating a Telnet Session
This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer. Follow these instructions to issue Telnet commands.
Step Description
1
Identify the IP address of your Printer. (Note: See the Accessing the IP
address of your Printer.)
2 Initiate a Telnet session from a DOS window on your PC. At the DOS prompt,
enter telnet [IP Address]
Example: C:\>telenet 192.168.11.12
 All Telnet responses from the Printer will then be displayed in the
Telnet session on the PC.
 All commands entered will be sent to the Telnet client in the Printer.
3 Enter help or ? to get an on-window list of supported Telnet commands.

Fargo DTC400 Specifications

General

Brand	Fargo
Model	DTC400
Category	Printer
Language	English